Search:

Type: Posts; User: i lunn

Page 1 of 5 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    238
    Views
    38,975

    Do you mean engine scrapped or car scrapped?

    Do you mean engine scrapped or car scrapped?
  2. Replies
    77
    Views
    24,549

    your welcome.

    your welcome.
  3. Replies
    77
    Views
    24,549

    [QUOTE=c2gt16;419335] that sounds like the peg...

    that sounds like the peg is not attached to the mount, it could be there is damage to the face of the mount where peg is sheared off stopping it sitting flush or the mount is rotated, there is ONLY...
  4. Replies
    77
    Views
    24,549

    is the peg visible anywhere? they could have...

    is the peg visible anywhere? they could have snapped it off by accident, if i remember right its only cast alloy so it would not take much to snap it while alining it up.
  5. Replies
    13
    Views
    1,087

    If you don't have proper diagnostic unit I would...

    If you don't have proper diagnostic unit I would be going down the change crank sensor route as it looks like it is quite likely to be cause. but as mentioned diagnostic could find the problem before...
  6. Replies
    77
    Views
    24,549

    Not a good idea as the locating pin is there to...

    Not a good idea as the locating pin is there to do a job, if its wrong the geometry and therefore stering can be affected.
  7. Try email/pm Trek he sometimes has uprated...

    Try email/pm Trek he sometimes has uprated bearings.
  8. Replies
    3
    Views
    1,690

    there is another way to overcome the problem...

    there is another way to overcome the problem (works the same as load resister) splice bulb holder into indicator wiring inside car and fit 21 watt bulb put it out of site and keep in mind it gets hot.
  9. Replies
    2
    Views
    739

    I fitted new one which lasted a week. Was quicker...

    I fitted new one which lasted a week. Was quicker to get one local then seller (ebay item) refunded the money to me.
  10. Thread: sssshhhhhh

    by i lunn
    Replies
    14
    Views
    1,591

    I noticed that as well.

    I noticed that as well.
  11. Replies
    9
    Views
    2,311

    If Its a cable loom any good auto electrician...

    If Its a cable loom any good auto electrician should be able to repair it or fit one from breakers yard.
  12. Replies
    9
    Views
    2,311

    You would be better trying to find a small...

    You would be better trying to find a small independent Citreon specialist (make sure he has proper Citreon diagnostic gear) the problem with dealer is they will just want to put new gearbox on its...
  13. Replies
    9
    Views
    2,311

    You need to get it connected to dealer level...

    You need to get it connected to dealer level software (no general diagnostic software will work correctly) "Lexia" is the name it will check sensors on gearbox, It could also be loosing a signal from...
  14. Replies
    3
    Views
    1,522

    forgot to add this:-...

    forgot to add this:-
    https://www.ebay.co.uk/itm/Peugeot-Citroen-MA-Gearbox-Front-Oil-Seal-Clutch-Bearing-Guide-Tube-2105-38/273141956285?hash=item3f98877ebd:g:vT0AAOSw1URaxI6Q
  15. Replies
    3
    Views
    1,522

    seems "edit" post no longer exists, any way here...

    seems "edit" post no longer exists, any way here is the item i think you are wanting but DONT buy it SEND me a PM with your address you can have the one I have in Garage, Its new and of no use to me...
  16. Replies
    3
    Views
    1,522

    Yes replace it they are not very expensive. I...

    Yes replace it they are not very expensive. I will try get part number for you.
  17. Replies
    7
    Views
    1,653

    We buy any car also are even known to have asked...

    We buy any car also are even known to have asked seller to pay them to purchase sellers car as they also charge admin fee for the paperwork, car was (to them) worth less than admin fee.
  18. Replies
    9
    Views
    1,734

    Trek is the most experienced so try his...

    Trek is the most experienced so try his suggestions first.
  19. Replies
    9
    Views
    1,734

    is fuel tank breather blocked / next time it...

    is fuel tank breather blocked / next time it stops remove filler cap to allow air back into tank, thinking posable vacuum
  20. Replies
    126
    Views
    25,358

    pictures not working

    pictures not working
  21. Replies
    5
    Views
    1,982

    sounds nice

    sounds nice
  22. Replies
    6
    Views
    1,794

    you could do more harm than good, it can block...

    you could do more harm than good, it can block things that you don't want.
  23. Thread: C2 CV joint

    by i lunn
    Replies
    9
    Views
    1,585

    Where is "North West Ingerland" maybe someone...

    Where is "North West Ingerland" maybe someone local who can help.
  24. Replies
    0
    Views
    1,346

    lexia software fully installed on tablet.

    I.m Selling my car so if anyone is interested in buying my lexia software fully installed and working on a tablet complete with cables.
    looking for 100 + postage (please text post code for postage...
  25. Replies
    9
    Views
    2,391

    Hi OzVTR Well not been able to reply to any...

    Hi OzVTR
    Well not been able to reply to any posts for getting on for a month now so as Forum is back up and running found the problem turned out to be random loss of brake signal.
    Thanks for your...
Results 1 to 25 of 112
Page 1 of 5 1 2 3 4